How To Make Finger Joints Without A Table Saw?
You’ve likely seen finger joints, those little squares that connect two pieces of wood in a nearly perfect way, regardless of whether you are a woodworker. These joints are often used in furniture construction. They can help make your project appear more professional.
The bad news is that if you dont have a table saw, making finger joints can be quite challenging. There is a way around this! This blog post will show you how to make finger joints using a table saw.
Woodworking can be a fun and rewarding hobby, but it can also be challenging especially when it comes to tools as the table saw.
-
First, measure the length and width of your piece. Next, divide it into fingers according to how many pieces you have. Finally, align both horizontal lines so that they are cut at specific depths.
-
It is essential to clamp the wood securely in order to ensure a precise cut. This will eliminate errors during cutting and make it easier to sand later.
-
Use a back tenon to create finger joints. Cut along the marked points vertically with a saw until you get the desired number. This process should be repeated for each finger joint so that they are equally spaced in relation to the number of fingers each one will have after it is done.
-
When it comes to cutting curves and shapes in wood, there is no better tool than a coping saw. This type of blade has been designed specifically for these tasks so you can easily make complex cuts along the horizontal lines while achieving deep vertical ones with just an angle grinder or even power tools if necessary. Always use a different cutting method to create joint between the pieces of wood. And remember to use a chisel for finishing and precise measurements since this will ensure perfect fitting once done.
-
When youre done with the first wood, repeat this process for another piece that will interlock perfectly when combined. To ensure that the pieces fit together well, make complementary joints by making opposite cuts.
Tools:
The Pros And Cons Of Making Finger Joints Without A Table Saw
Pros
- It’s much cheaper to do it this manner
- its more portable you can take it with you wherever you go
- It is easier to use than a tablesaw
- It is more precise than a table saw
- it is a relatively simple process and it does not require a lot of equipment
- its more fun to make
Cons
- You will need a moulding head to use your drill press
- the bit has to be exactly on centre or your fingers wont come outright
- It is more difficult on the wrist to use a table saw, especially if you do this for hours.
- it will not work with all types of woodspoplar and pine are probably best
- you have to have an extremely steady hand in order for this method not to turn out sloppy looking. Don’t expect things to improve if you aren’t well coordinated before you start this project.
Conclusion:
It can be difficult to make finger joints without a tablesaw. But with some practice and these tips you will be able do it like a pro. The most important thing is to take your time and be careful. Remember, its always better to go slow and get things right than to rush through the project and end up with sloppy-looking fingers.
